What happened: Vehicle has experienced failure of the Footwell Control Module (FRM) and associated wiring harness in the driver footwell area, consistent with NHTSA Recall 23V-337. Symptoms: • Exterior lights (headlights / taillights) remain illuminated far longer than normal after vehicle shutoff, sometimes not turning off at all. • Inspection revealed melted wiring, melted connector plugs and receptacles for headlight/taillight circuits. • Water was found in driver side footwell in the past / under carpet padding. Carpet pad is saturated. This is the same failure mode described in Recall 23V-337: "Due to a number of contributing factors, over time, the FRM could become susceptible to corrosion. Eventually, the corrosion could potentially result in a short circuit, resulting in a potential thermal event which could increase the risk of a fire or injury." Safety risk: Melted wiring and connectors create short circuit and thermal event risk, including fire risk while vehicle is parked and unattended. Lights failing to shut off creates dead battery / loss of exterior lighting control. I am concerned about vehicle fire. My vehicle shows evidence of having caught fire at the headlight and receptacle point. Recall history: Vehicle is included in NHTSA Campaign 23V-337000 (MINI Recall 23V-337 - Footwell Module Moisture/Water Intrusion). I was told remedy is still being developed / parts unavailable, or that additional wiring harness damage beyond the FRM itself is not fully c